Water softeners should be an integral part of your espresso machine. The mineral content of water can build up limescale inside your favorite espresso machine. Most espresso machine manufacturers cancel their limited warranties, if their machine is not installed with a water softener and recharged accordingly. Inoxdep Water Softener 8 Liter w/ Bypass features one multi-step valve for use, recharge, discharge, etc. It is rechargeable with salt, easily available on any plumbing supply house or a local hardware. The unit does not need a filter cartridge replacement.

•    Working Pressure: 1 Bar (min.) - 8 Bar (max.)
•    Water Temperature Requirements: 4 degree C (min.) - 15 Degrees C (max.)
•    Regeneration Salt Capacity: 1kg/2.2 Pounds
•    Flow Rate: 1,000 Liters per hour
•    Requirements: 3/8F thread, additional 7" of height clearance to remove top cover and add salt for recharge, and additional 4" froth width clearance to attach inbound and outbound water lines
•    Measurements: 10" D x 7.5" W x 17" H (overhead clearance needed is about 8")
•    Capacity: 8 liters


Please Note:
•    Stainless Steel braided hose and drain hose are sold separately. They are not included with water softener.
•    Use this softener where the room temperature is more than 37 degrees Fahrenheit.
•    Use only potable water through this softener.
•    Never remove the internal resins.

(The interval schedule for regeneration depends on your water hardness. But it’s normally recommended 1-2 times per month.)